SynthMaker Production Manual Open SynthMaker (opens in a new tab)
Music production

Music production: hear how it works

How music production works, one question at a time. Every page answers one question in plain words, with the numbers worked out and before-and-after sounds you can play right there.

The whole plan is below, chapter by chapter: written pages are links, and the rest are planned. Later chapters build real studio circuits (an EQ, a compressor, a spring reverb) part by part.

The plan grows and changes as it's written; tell us what you'd like next.

Start hereWhat is music production?

1Getting started

2Frequency and EQ

Planned

  • What an EQ does: cut, boost, shelf and bell
  • Carving space: making two sounds fit
  • A tone stack, part by part circuit
  • A parametric band, part by part circuit

3Saturation and warmth

Planned

  • Why a little distortion sounds warm: harmonics
  • A diode clipper on a mix circuit
  • A valve preamp circuit

4Dynamics: compression

Planned

  • What a compressor does: threshold, ratio, attack, release
  • An optical compressor, part by part circuit
  • Compression you can hear vs compression you feel

5Glue and loudness

Planned

  • A bus compressor: gluing a mix circuit
  • Limiting: the last stage, and why SynthMaker's master looks ahead

6Groove: sidechain

Planned

  • The pump: one sound ducking under another

7Space and depth

Planned

  • Panning and width
  • Delay and chorus with a bucket-brigade chip circuit
  • Reverb: rooms, halls and a spring tank circuit

8Arrangement and energy

Planned

  • Building and breathing: arcs, drops and space
  • Fewer parts, better parts: why busy sounds confusing

9Finishing a song

Planned

  • Mixing a whole song: Lift, before and after
  • Remastering: what changed in Lift, and why
  • Mastering and translation: checking on a phone, headphones and speakers; reference tracks