SynthMaker runs in your browser. Nothing to install. Open it →
SynthMaker

Real circuits you can play.

Type a parts list and SynthMaker draws the schematic and plays it, simulated part by part, in your browser. The simulator is tested against ngspice, a standard circuit simulator.

In your browser on any computer, iPhone or iPad. Nothing to install. On a Mac, there's also an app.

Filament's ladder filter unit in 3D, its cutoff and resonance knobs, with patch cables in its jacks, under the words THE FILTER SINGS.
Six real circuits, each built part by part in SynthMaker.
Pedal · the parts list
circuit Pedal  setting input: 6 V, from 0.5 V to 40 V  setting output: 0.65 V, from 0.1 V to 2 V  setting tone: 15k, from 1.5k to 150k  R1 in a 2.2k  C1 a gnd 10n  D1 a gnd 1N4148  D2 gnd a 1N4148  R2 a out tone  C2 out gnd 10nend
Scope · a

Press Play to see the wave inside the circuit, at a.

A short riff through the circuit, round and round. Turn the knobs while it plays. Open in SynthMaker ↗ (opens in a new tab)

Filament: a modular synth, one real circuit at a time →

Filament: a modular synth, one real circuit at a time

A case of hardware-style units, each a real circuit simulated as it plays. Hear the whole case, then play each unit's circuit in your browser.

Being built in the open, unit by unit.

The whole case plays in SynthMaker for Mac. Each unit's circuit plays here in your browser.

Filament's case: hardware-style synth units from six makers in two rows, joined by patch cables.

Turn a circuit into a module, and patch it with cables.

Give a circuit a face of knobs and jacks, then wire it to oscillators, envelopes, sequencers and drums, cable by cable. The cables carry real voltages, and you can see the signal move through every one.

Watch it built: Circuits 6 tutorial

Circuits 6's Acid in the Patch: Voice into Acid, a module made from a circuit, its face of jacks inside its box (Saw, Filter in, Envelope, Cutoff, Steps, Resonance) with three cables plugged, on to the Output

Plug in a guitar and play through a real circuit.

Audio In brings your guitar, mic or any sound into the patch, and Audio Out sends it on. Run it live through a simulated pedal circuit (a diode clipper, a fuzz, a wah) or any chain of modules, and turn the knobs as you play.

Use headphones or an audio interface: every sound opens muted, and nothing plays until you turn Monitor on.

A guitar through a diode clipper: Audio In wired into the Pedal circuit and on to Audio Out in the Patch, with the same sound as code beside it, the circuit's parts list included

Write it as code or wire it as a patch: they stay in sync.

Every sound is both a patch and a few lines of code. Change a wire and the code updates; edit the code and the patch redraws. Define your own DSP modules the same way: as maths in code, or as a patch of other modules. And paste any sound into a forum post, where it plays right there.

Tutorial: Your synth as code

Smooth Pluck as a patch and as code side by side: the Patch's modules and wires on the left, the same sound in syntax colours on the right

A free course on the circuits inside pedals and synths.

From a voltage divider to a transistor ladder filter: clippers, op-amps, fuzz, VCAs, filters and more. Every page answers one question in plain words, works the numbers out, and lets you play the circuit with its own knobs and buttons. New pages are added all the time.

Start with the voltage divider See all the circuits

Instruments built from physics, with no samples.

A cello from a bow, a string and the measured body of a real cello. A grand piano from hammers, strings and a soundboard. A guitar string plucked out of noise. Every part is a module you can open.

The Concert Grand in the Patch: a Hammer strikes the Piano strings, and their sound rings through a Soundboard, with no samples anywhere

Lessons that build it with you.

In each lesson, Ned builds a sound in front of you, inside the app, step by step, then stops for you to try. Every lesson has a matching tutorial on YouTube.

Watch the tutorials

A lesson in the app: Ned's card, Circuits 1, A distortion pedal from six parts, explains the diodes while the Pedal's parts list and schematic sit side by side, with its knobs

From one sound to a whole song.

Songs with several instruments, step and Euclidean sequencers, and generators that write parts for you. An Analyzer after any module shows its spectrum, scope and spectrogram.

A song in the app: Acid Line's tracks (Acid, Kick, Snare, Hat) beside the Acid module opened, its oscillator, envelopes, LFO and Steps pattern wired into the OTA filter circuit

Listen: Lift

A whole song made in SynthMaker: chords that pull and then resolve, a filter that sings, a bass that goes from clean to growl, a felt piano and a cello.

Every melody and rhythm comes from SynthMaker's generative modules; none of it is written by hand.

The cello and the piano are patches from SynthMaker's lessons, and SynthMaker's conductor brings its parts in and out. Meet the conductor →

Rendered offline by SynthMaker's own engine at full circuit quality, from one song patch, with nothing added afterwards.

How it's made: the ingredients →

More music →

· 4:580:00

In your browser and on the Mac, with your sounds in both.

Start a sound in the browser on any computer, carry on in the Mac app: sign in and your sounds and songs are in both. The browser needs nothing installed; the Mac app adds hosting the AUv3 instruments and effects you already own as modules.

SynthMaker for Mac

A forum where your patches play inside the post.

Share a sound in a forum post and it plays right there, as a card with its own Play button, ready for anyone to open in SynthMaker and change. Ask questions, show what you made, suggest ideas, and hear each other's patches without leaving the page.

Visit the forum How to share a patch

A patch playing inside a forum post: My First Face, shared by jorge, its knobs, its Patch with the signal moving along the wires, and its code, with Stop and Open in SynthMaker

Free to play and learn.

Playing, turning knobs, looking inside any module, every free lesson and the circuits course cost nothing. SynthMaker Pro unlocks building your own: making and editing circuits, code and modules, and the rest of the lessons. It's a one-time purchase.

What Pro unlocks

From the creator of the original SynthMaker

Jorge Costa created SynthMaker for Windows in 2005, a visual way to build synthesizers from modules. This is a new SynthMaker, written from scratch for the web and the Mac, with its own audio engine.

Follow along on YouTube, where every tutorial builds an instrument or a visual live in the app.

The cello in the Patch: a Bow and a Vibrato play the Cello string, through a VCA, and every voice rings through the Cello body and a Reverb