Your guitar through a patch, the CPU each module takes, and patch cables.
Audio In and Audio Out: wire a guitar, a microphone or an audio interface into Audio In, through any patch, and out of Audio Out, with no key held. Choose each box's device on its card. Every sound opens muted until you turn on Monitor, and the card shows the delay from input to output.
How much CPU: a readout by Play shows how much of the Mac a sound takes, with its peak. Show CPU in the Patch's bar gives each module's share, live, and a custom module's total inside it.
Jacks and patch cables: give a face a jack for any port inside it and pull a cable from jack to jack. The wire is there in the Patch, the same as one you drew. Switch Wires to Cables to see every wire hanging as a cable.
Circuits 3: the lesson that builds a sample and hold from noise, a JFET switch and two op-amps, with a JFET part and named inputs for circuits.
Every release, with pictures: What's new. Tell us what you think, and share what you make, at synthmaker.com/forum.