From the original SynthMaker forum (2004–2014), with its members’ names and dates.
ccpurno ·
Hi,
smooth line draws fine inside SM 1.1.6, but as soon as I touch the smooth knob in any VST it jumps to a phase shift.
See picture. Seems the phase shift is getting worse to the right side. Also confirmed in stock LFO.
Test with attached schematic.
CC
stw ·
The example.osm works fine here.
EDIT: And so does the original STEP LFO from the Modelling Kit
MichaelBenjamin ·
i also cannot see the shift, are you sure you did not mod it and introduced some error? looks like the freqency is off for the smoothed line.
Acrobat ·
ccpurno wrote: Hi,
smooth line draws fine inside SM 1.1.6, but as soon as I touch the smooth knob in any VST it jumps to a phase shift.
See picture. Seems the phase shift is getting worse to the right side. Also confirmed in stock LFO.
Test with attached schematic.
CC
Probably you are using a samplerate other than 44100 Hz...that causes the bug. I
ccpurno ·
Probably you are using a samplerate other than 44100 Hz...that causes the bug.
Confirmed! Phase shift only happens at sampe rates other then 44100 Hz. I delved into the schematic and think something is going wrong in the freq module. But after checking it outputs the correct sample rate..
Wonder where its going wrong.
CC
Acrobat ·
ccpurno wrote: Wonder where its going wrong. CC
The fact is the visualization is done just by doubling the audio part, using a ramp, etc.. if GUIfied properly, it won't go nuts so easely, should be written back from scratch... 😉
ccpurno ·
ok, solved it!
I added a float sample and hold after the freq module. See picture and attached schematic.
Sample and hold shouldn't be needed though (?) Still a bug?
CC
Wrote something here? To have a post removed or your name hidden, write to [email protected].
SynthMaker