SynthMaker

Can I access the offsets frin the GUI frontpanel?

Archive · 2007 2 old posts

From the original SynthMaker forum (2004–2014), with its members’ names and dates.

oddson ·

If I move a module using the GUI front panel, can I access the offsets numerically from within S|M?

I.e.:

The data (shown here as pixels) as offsets (most likely as grid offsets but either would work).

rl ·

I noticed that too. While you can set the position using the MGUI's x- and y position you can't read the actual position. On the other hand it's possible to read width and height, but not set it.

So ideally the MGUI should have 4 float ins and 4 float outs (x,y, width, height)

Wrote something here? To have a post removed or your name hidden, write to [email protected].

Before your first post

A few rules keep this a friendly place. You agree to them once.

Shown next to what you post, here and in the app. It doesn’t have to be your real name: 3–24 lower-case letters, digits or _ (capitals become lower case, spaces become _).

    Then your post goes up straight away.

    Delete this reply?

    Open it in SynthMaker?

    It goes on the track you’re editing there, in place of that track’s sound, and into My sounds. Your other tracks stay as they are.

    Want to keep that track’s sound? Start a new song in SynthMaker first (Song › New song), then open this.

    Report this reply?

    Only the developer reads reports. The person isn’t told who reported them.

    What’s wrong with it?

    Block this person?

    You won’t see their posts and replies here any more. They aren’t told, and you can unblock them at any time.

    People you’ve blocked

    Their posts and replies are hidden from you. Unblock someone to see them again.

    The community rules

    A few rules keep this a friendly place. Everyone agrees to them once, before their first post.