From the original SynthMaker forum (2004–2014), with its members’ names and dates.
autodafe ·
How is that possible ?
i am trying using the TimeInfo Module connected to the standard pre-built LFO, but i need to convert Tempo (BPM) into Hertz...which is the usual formula ? and therefore, toi sync to 1/4 th note, is it just enough to divide Hertz/4 ???
autodafe ·
should I just divide Tempo by 60 ????
stefan ·
If you divide beats/minute by seconds/minute, you get beats/second, which is the same as hz, so yes, divide by 60 🙂
autodafe ·
thanks stefan, I think i got it... i made a modification to the standard LFo which adds sync to host tempo (from 1/16...to 16/4)..i simply multiplied the hertz by partials (like 0.25 for 1/4th note)...I am testing it in cubase and looks like it's working good... putting finishing touches, will post it in some minutes...
autodafe ·
here's what i did...sounds correct???
http://www.autodafe.net/SynthMaker/LFO_TempoSync.osm
(sorry for the HUGE pic, I only Have MS Paint on this machine)
oddson ·
autodafe wrote: ...sorry for the HUGE pic, I only Have MS Paint on this machine...
SM has a 'Capture' command under the view menu. It will grab only the schematic part and offer you a save dialog.
If you make the schematic part of the user interface smaller you can grab what you want without using any other application...
autodafe ·
thanks, i discovered it today AFTER making that HUGE pic;-) ...i will try to edit my post 😉
skOre ·
Also, we now have some good guess where you come from 🙂
autodafe ·
😉
autodafe ·
edited the pic...a bit better now, right ??? 😉
oddson ·
As far as I can tell your schematic works as expected.
You could increase the max rate of the variable LFO - 1 Hz is pretty slow for most uses I would think.
But this can be done from the properties.
Alternately you could use a centre based dial that takes the basic rate from tbe beat values and alters that... or not. 😉
Wrote something here? To have a post removed or your name hidden, write to [email protected].
SynthMaker