From the original SynthMaker forum (2004–2014), with its members’ names and dates.
distante ·
Hello again! I have now my second question :P
See, I want to use the "IF THEN ELSE" primary component (it's primary don't?) to check if a Switch button is on or off and then make turn on an oscilator ( by changing the frequency to 0=off 1khz=on).
But I can't understand how this component works, I know how to do this in algorithm, but with this graphical control I can't make it work...
For example, I need to change the "type of data to compare" to bool but I can't find the way to do this. In the manual just say:
For this component the If input defines the control variable this could be an int, float or string. You
specify which of these using the Type input (either “int”,”float” or “string”).
"Type input" it's a component? because when I clic o double chick in the "type" button in the IF THEN component nothing happens
Can't find the way to change the OP neither 🙁
tektoog ·
Right now you can play the OSC when switch is off.
If you want the opposite, to be able to play the OSC when switch is on, just change the 0 value to 1 in the conditions setting.
Hope it helps...
trogluddite ·
Also, check out this old post... If Then Else
distante ·
Thank you both! That was a huge help! 🙂
Now I have to figure out how to copy modules from one osm to other hehe!
Tzarls ·
Open both schematics using the same instance of SM, then use the usual ctrl+c / ctrl+v.
At least that´s how it used to be. 😉
distante ·
Tzarls wrote: Open both schematics using the same instance of SM, then use the usual ctrl+c / ctrl+v.
At least that´s how it used to be. 😉
Oh great, every time I open a modulewith double-clic this also opened a new instance of SM, now I just drag the schematics and the Ctrl+C/ Ctrl+V works fine Thank you Tzarls
Wrote something here? To have a post removed or your name hidden, write to [email protected].
SynthMaker