From the original SynthMaker forum (2004–2014), with its members’ names and dates.
galaa ·
This is probably dead easy (if you know how), but its doing my head in! I'm using the standard SM switches to control modulation routing and I want them to load up turned off. But they all load up turned on. I'm digging around inside the switch but I can't seem to figure it out.
Does anyone have any ideas?
cheers galaa
skOre ·
Sounds as if you would need presets maybe?
galaa ·
I figured out a rather inelegant solution:
I swapped the 2 images round inside of the switch so that the on/off images are reversed
Then I did a little bit of logic so that the switch still outputted the correct values
Like I said, not pretty, but it works
galaa
Tom7777 ·
As skOre says it could be to do with the presets, maybe try deleting the preset module which might be set as 1, then set the switch to off and use a new copy of the module, then im guessing it would always start with the switch turned off, i know you have made a workaround already this is just another way to do it. 🙂
Wrote something here? To have a post removed or your name hidden, write to [email protected].
SynthMaker